Fig. 5From: Methods and tools for handling, transportation, weighing, and pelletization applied to the initial analysis of volatile components in the Hayabusa2 samplesSchematic diagram of the stainless-steel (SS) holder that had an outer diameter of 1 cm and was named as 1 cm SS-holder. a. Main block with a thin (50 µm) tungsten (W) face plate. b. Spring-loaded lid with a spring coil. c. Cross-section image when the Cu disk was installed in the 1 cm SS-holder. The sample surface was adjusted to the 50 µm below the W face plateBack to article page